BERTUCCI'S
FAILWednesday, May 27, 2015 at 6:20 PM
Violations Cited
03-3-501.16(A)
Cold Holding
Cold holding in reach in refrigerator between 45F to 50F. Keep lids down to help with temperature and monitor. If no improvment address with service company.
Why This Matters
THE DANGER ZONE KILLS: Between 41°F-135°F bacteria double every 20 minutes. At 70°F, 10 bacteria become 10,000 in 2 hours, 10 million in 4 hours. Staphylococcus aureus produces heat-stable toxins that cooking cannot destroy. Clostridium perfringens causes 1 million illnesses yearly from temperature abuse. Listeria grows even under refrigeration, killing 20% of victims including pregnant women and newborns.
Code Requirements
ALL TCS foods MUST be held at 41°F or below at ALL times. This includes: All meat, poultry, seafood; Dairy products; Cut melons, tomatoes, leafy greens; Cooked rice, pasta, potatoes; Tofu, soy products; Sprouts; Garlic in oil. Check temperatures every 2 hours (4 hours maximum). If above 41°F for less than 2 hours, rapidly cool. If above 41°F for 2-4 hours, use immediately. If above 41°F for over 4 hours, DISCARD.
Corrective Actions
IMMEDIATE: Check ALL refrigerated foods NOW; Discard any food above 41°F for >4 hours; Rapidly cool foods 41-70°F if <4 hours; Repair/adjust all refrigeration immediately; Reduce inventory to prevent overstocking; Install thermometers in warmest part of all coolers; Implement 2-hour temperature checks; Create power outage procedure
14-4-202.11
Food Contact Surfaces Design
Clean or replace all cutting boards that have deep dark stains.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
15-4-202.16
Non-Food Contact Surfaces
Repair drain to refrigerator on cookline. Leaking onto floor.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
23-4-602.13
Non-Food Contact Surfaces Clean
Clean shelves in walk in refrigerator of build up.
Why This Matters
INDIRECT CONTAMINATION: Dirty surfaces attract pests, harbor bacteria, and contaminate via contact or air movement. Dust from dirty shelves contains allergens affecting 32 million Americans. Grease accumulation creates slip hazards causing 25% of restaurant injuries.
Code Requirements
Non-food contact surfaces must be cleaned at frequency to prevent: Soil accumulation; Pest attraction; Contamination of food/food contact surfaces. Includes: Equipment exteriors; Shelving; Walls and ceilings; Light fixtures; Ventilation systems.
Corrective Actions
Deep clean all non-food contact surfaces; Create cleaning schedule with daily, weekly, monthly tasks; Assign cleaning zones to staff; Use degreaser for grease accumulation; Clean from top to bottom; Maintain cleaning log
37-6-501.11-.12
Improper Maintenance of Walls/Ceilings
Wash walls in warewashing area of dry food. Replace any caulking that is stained black or in need of repair. Hood filters visibly soiled clean to remove grease build up. Hood not do to be cleaned until July 2015 Repair wall by three bay sink. Missing tile and metal plate falling off.
Why This Matters
OVERHEAD CONTAMINATION: Peeling paint and debris fall into food. Condensation on ceilings drips bacteria onto prep surfaces. Studies found ceiling tiles harbor Bacillus cereus spores. Restaurant ceiling collapse contaminated food service for 200 guests.
Code Requirements
Walls/ceilings must be: Smooth and washable in food areas; Light-colored for easy soil detection; Free of holes, cracks, peeling paint; Sealed at all joints and attachments; Clean and free of grease, dust, cobwebs; Non-absorbent in areas subject to moisture.
Corrective Actions
Repair all holes within 14 days; Repaint with washable paint; Replace damaged ceiling tiles; Seal all penetrations; Clean walls and ceilings monthly; Fix any leaks immediately; Install FRP panels in splash zones