Caribbean Flavors
PASSTuesday, January 23, 2024 at 7:19 PM
Violations Cited
590.003(C)/3-301.11-P
Preventing Contamination from Hands (P)
Employees observed slicing ready to eat produce without wearing gloves. Discontinue and ensure no bare hand contact with any ready to eat foods.
Why This Matters
Inadequate handwashing is a leading cause of foodborne illness transmission
Code Requirements
Immediate correction required. Follow health code section 105 CMR 590.003(C). Implement proper personal hygiene procedures. Train all staff. Document corrective actions taken.
590.003/3-501.16-P1
(A)(1) Time/Temperature Control for Safety Food Hot and Cold Holding (P)
Beef patties in the front service hot holding unit at 111F. Discontinue and ensure all TCS foods are being maintained at at 135F and above. Patties to be reheated to 165F to ensure no bacterial growth.
Why This Matters
RAPID BACTERIAL GROWTH: At 50°F, E. coli doubles every 30 minutes. At 70°F, it doubles every 20 minutes. After 4 hours above 41°F, bacteria can reach dangerous levels causing severe illness. Common result: 24-72 hours of diarrhea, vomiting, fever, potential hospitalization.
Code Requirements
Immediately discard foods held above 41°F for over 4 hours. Rapidly cool foods above 41°F if less than 2 hours. Check ALL cooler temps every 2 hours with calibrated thermometer. Repair/adjust refrigeration immediately. Never store food in non-refrigerated areas.
590.004/4-602.13-C
Nonfood Contact Surfaces (C)
Interior of the single door cooler located next to the flat top burner with excess frost build-up. Defrost and clean to remove.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section 105 CMR 590.004. Implement proper food safety procedures. Train all staff. Document corrective actions taken.
590.006/6-201.11-C
Floors Walls and Ceilings-Cleanability (C)
Hood and Ventilation tags with a past expiration date from Sept. 2023. Address and provide up to date tags for the re-inspection.
Why This Matters
Poor facility maintenance can harbor pests and prevent proper cleaning
Code Requirements
Smooth, non-porous surfaces; Properly sloped to drains; No gaps or cracks; Maintained clean