Down Home Delivery & Catering
FAILThursday, April 11, 2024 at 6:12 PM
Violations Cited
590.006/6-501.111-PF
Controlling Pests (Pf)
Evidence of what appears to be rodent droppings on the storage shelves where large containers of oil is being stored.Clean to remove and provide an up to date pest control report for the re-inspection.
Why This Matters
SEVERE CONTAMINATION: Rodent droppings carry 35+ diseases including Hantavirus (36% mortality rate), Salmonella (20% of cases from rodents), Leptospirosis (kidney/liver failure). Mice contaminate 10 times more food than they eat through urine and droppings.
Code Requirements
IMMEDIATE ACTION: Clean/sanitize all affected areas with 10% bleach solution. Discard ALL exposed food. Seal holes over 1/4 inch (mice) or 1/2 inch (rats). Remove food sources. Install bait stations. Professional extermination within 24 hours.
590.003/3-304.14-C
Wiping Cloths Use Limitation (C)
Soiled wiping cloths observed being left out on counter tops with sanitizing solution. Provide.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section 105 CMR 590.003. Implement proper food safety procedures. Train all staff. Document corrective actions taken.
590.003/3-501.13-C
Thawing (C)
Large containers of fish fillets observed being thawed at room temperature. Discontinue and ensure proper thawing methods are in place.
Why This Matters
SURFACE CONTAMINATION: Room temperature thawing allows surface to reach 70°F+ while interior frozen. Bacteria multiply 7-fold every hour. Creates perfect conditions for Salmonella, Campylobacter growth. Major factor in poultry-related illnesses.
Code Requirements
Approved thawing methods ONLY: Under refrigeration (best), Under cold running water (70°F) in sink, In microwave if cooking immediately, As part of cooking process. NEVER at room temperature. Plan ahead for slow thawing.
590.004/4-202.16-C
Nonfood-Contact Surfaces (C)
Drainage to from the compressor of the walk-in cooler is not connected. Address and make any necessary repairs to ensure proper drainage. Door to the large coffin style freezer in the back storage room is damaged and not closing properly. Address and either repair or replace.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section 105 CMR 590.004. Implement proper food safety procedures. Train all staff. Document corrective actions taken.
590.004/4-602.13-C
Nonfood Contact Surfaces (C)
Heavy grease build-up observed around cooking line equipment. Clean to remove all. Interior of both Blogett ovens with excess carbon build-up. Clen to remove. Storage shelves located where the large containers of oil are being stored visibly soiled. Clean to remove.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section 105 CMR 590.004. Implement proper food safety procedures. Train all staff. Document corrective actions taken.
590.005/5-205.15-C
System Maintained in Good Repair (C)
Faucet to the 3 bay sink has a pin hole in it and leaking. Address and make any necessary repairs. Hot and cold water faucets at the hand sink located directly next to the 3 compartment sink not functioning properly. Replace or repair.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section 105 CMR 590.005. Implement proper food safety procedures. Train all staff. Document corrective actions taken.
590.006/6-201.11-C
Floors Walls and Ceilings-Cleanability (C)
Hood and Ventilation tags with a past expiration date from Dec. 2023. Address and provide up to date tags for the re-inspection. Portion of floring located near the 3 bay sink with low grout levels. Regrout in order to prevent any standing water (breeding ground for fruit flies).
Why This Matters
Poor facility maintenance can harbor pests and prevent proper cleaning
Code Requirements
Smooth, non-porous surfaces; Properly sloped to drains; No gaps or cracks; Maintained clean