Liberty Diner
FAILThursday, November 15, 2018 at 3:04 PM
Violations Cited
03-3-501.14
Cooling
Found two shallow containers in walk in covered tight and was told potatoes cooling just boiled. I review with staff to properly cool and then cover and store.
Why This Matters
This violation directly contributes to foodborne illness risk
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
03-3-501.16
Hot Holding
Home fries between 74F to 94F. PIC will reheat and hot hold about 140F. Reheat smaller amounts if you do not have space of grill or provide a hot holding unit.
Why This Matters
This violation directly contributes to foodborne illness risk
Code Requirements
Maintain all hot TCS foods at 135°F or above; Cannot use hot holding equipment to reheat
03-3-501.16(A)
Cold Holding
Egg wash in two locations between 50F to 53F. PIC put into walk and closed lid to reach in. Monitor
Why This Matters
THE DANGER ZONE KILLS: Between 41°F-135°F bacteria double every 20 minutes. At 70°F, 10 bacteria become 10,000 in 2 hours, 10 million in 4 hours. Staphylococcus aureus produces heat-stable toxins that cooking cannot destroy. Clostridium perfringens causes 1 million illnesses yearly from temperature abuse. Listeria grows even under refrigeration, killing 20% of victims including pregnant women and newborns.
Code Requirements
ALL TCS foods MUST be held at 41°F or below at ALL times. This includes: All meat, poultry, seafood; Dairy products; Cut melons, tomatoes, leafy greens; Cooked rice, pasta, potatoes; Tofu, soy products; Sprouts; Garlic in oil. Check temperatures every 2 hours (4 hours maximum). If above 41°F for less than 2 hours, rapidly cool. If above 41°F for 2-4 hours, use immediately. If above 41°F for over 4 hours, DISCARD.
Corrective Actions
IMMEDIATE: Check ALL refrigerated foods NOW; Discard any food above 41°F for >4 hours; Rapidly cool foods 41-70°F if <4 hours; Repair/adjust all refrigeration immediately; Reduce inventory to prevent overstocking; Install thermometers in warmest part of all coolers; Implement 2-hour temperature checks; Create power outage procedure
22-4-601/602.11
Food Contact Surfaces Clean
Can opener in kitchen visibly soiled. Clean to remove build up.
Why This Matters
BIOFILM FORMATION: Visible soil indicates biofilms - communities of bacteria protected by slime layers that resist sanitizers. Biofilms on slicers have caused Listeria outbreaks killing 30% of victims. Meat slicer contamination sickened 300 across 6 states. Grease harbors Listeria which grows at refrigeration temperatures.
Code Requirements
Food contact surfaces must be: Visibly clean with no food debris; Free of grease accumulation; Smooth and cleanable; Cleaned and sanitized after each use; Cleaned every 4 hours if in continuous use; Equipment must be disassembled for cleaning when necessary.
Corrective Actions
Clean and sanitize ALL equipment immediately; Disassemble equipment for thorough cleaning; Establish cleaning schedule with assigned responsibilities; Use cleaning checklist; Train on proper disassembly; Increase cleaning frequency
04-3-501.15/4-301.11
Inadequate Facilities/Cooling Methods
Small one door reach in flip top next to grill at 45F. Have serviced. Must be at or below 41F.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
08-3-305-307.11
Food Protection
Discontinue to store product on he floor under shelves in walk in.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
17-4-204.112/.115
Equipment Thermometers
Replace missing thermometers for refrigerators in kitchen area.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper equipment procedures. Train all staff. Document corrective actions taken.
36-6-501.11-.12
Improper Maintenance of Floors
Clean floor in basement and kitchen. Clean under and behind equipment. Repair broken floor tiles in kitchen area.
Why This Matters
CONTAMINATION RESERVOIR: Damaged floors harbor bacteria in cracks. Standing water breeds Listeria, Pseudomonas. Broken tiles create pest harborage. Floor contamination spreads via shoes, equipment wheels, and dropped items. CDC found floor drains positive for Listeria in 40% of retail delis.
Code Requirements
Floors must be: Smooth and non-porous in food areas; Properly sloped to drains (1/8 to 1/4 inch per foot); Coving at wall junctures sealed; No cracks, holes, or missing tiles; Grout intact and sealed; Cleaned daily or more frequently; Dry except when cleaning.
Corrective Actions
Schedule floor repairs within 30 days; Seal all cracks immediately with approved sealant; Improve drainage to eliminate standing water; Increase cleaning frequency; Replace missing tiles; Re-grout as needed; Remove any carpeting from food areas
37-6-501.11-.12
Improper Maintenance of Walls/Ceilings
Clean walls pipes and attached equipment in kitchen area of grease build up. Clean ceiling in cooking area of grease build up.
Why This Matters
OVERHEAD CONTAMINATION: Peeling paint and debris fall into food. Condensation on ceilings drips bacteria onto prep surfaces. Studies found ceiling tiles harbor Bacillus cereus spores. Restaurant ceiling collapse contaminated food service for 200 guests.
Code Requirements
Walls/ceilings must be: Smooth and washable in food areas; Light-colored for easy soil detection; Free of holes, cracks, peeling paint; Sealed at all joints and attachments; Clean and free of grease, dust, cobwebs; Non-absorbent in areas subject to moisture.
Corrective Actions
Repair all holes within 14 days; Repaint with washable paint; Replace damaged ceiling tiles; Seal all penetrations; Clean walls and ceilings monthly; Fix any leaks immediately; Install FRP panels in splash zones