Slade's Bar & Grill
FAILFriday, June 1, 2018 at 6:11 PM
Violations Cited
03-3-501.16(A)
Cold Holding
Raw chicken in kitchen at 55F. PIC stated that it was being preped. It was delivered about 30mins ago. Only take out what can be prep so product stays below 41F
Why This Matters
THE DANGER ZONE KILLS: Between 41°F-135°F bacteria double every 20 minutes. At 70°F, 10 bacteria become 10,000 in 2 hours, 10 million in 4 hours. Staphylococcus aureus produces heat-stable toxins that cooking cannot destroy. Clostridium perfringens causes 1 million illnesses yearly from temperature abuse. Listeria grows even under refrigeration, killing 20% of victims including pregnant women and newborns.
Code Requirements
ALL TCS foods MUST be held at 41°F or below at ALL times. This includes: All meat, poultry, seafood; Dairy products; Cut melons, tomatoes, leafy greens; Cooked rice, pasta, potatoes; Tofu, soy products; Sprouts; Garlic in oil. Check temperatures every 2 hours (4 hours maximum). If above 41°F for less than 2 hours, rapidly cool. If above 41°F for 2-4 hours, use immediately. If above 41°F for over 4 hours, DISCARD.
Corrective Actions
IMMEDIATE: Check ALL refrigerated foods NOW; Discard any food above 41°F for >4 hours; Rapidly cool foods 41-70°F if <4 hours; Repair/adjust all refrigeration immediately; Reduce inventory to prevent overstocking; Install thermometers in warmest part of all coolers; Implement 2-hour temperature checks; Create power outage procedure
08-3-302.11/3-304.11
Separation Segregation Cross Contamination
Discontinue to store raw chicken above vegetables. Must be store properly as discussed. Large pile of collard green in three bay sink. Discontinue and only take out what you can prep.
Why This Matters
Cross-contamination can spread dangerous pathogens throughout the facility
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
14-4-202.11
Food Contact Surfaces Design
Provide a sivider for ice at bar for ice used for drinks and ice used to chill soda plate.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
16-4-501.11/.15
Dishwashng Facilities
Provide an area to store soiled equipmemt. Found soiled equipment in two bays of three bay and on floor under sink.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
17-4-302.14
Test Kit Provided
Provide a test kit for low temp dishwasher at bar and three bay. PIC had only one and rinse should be check by staff.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
23-4-602.13
Non-Food Contact Surfaces Clean
Clean interior and exterior of refrigeration equipment. Clean in place cooking and prep equipment. Clean shelves in kitchen area.
Why This Matters
INDIRECT CONTAMINATION: Dirty surfaces attract pests, harbor bacteria, and contaminate via contact or air movement. Dust from dirty shelves contains allergens affecting 32 million Americans. Grease accumulation creates slip hazards causing 25% of restaurant injuries.
Code Requirements
Non-food contact surfaces must be cleaned at frequency to prevent: Soil accumulation; Pest attraction; Contamination of food/food contact surfaces. Includes: Equipment exteriors; Shelving; Walls and ceilings; Light fixtures; Ventilation systems.
Corrective Actions
Deep clean all non-food contact surfaces; Create cleaning schedule with daily, weekly, monthly tasks; Assign cleaning zones to staff; Use degreaser for grease accumulation; Clean from top to bottom; Maintain cleaning log
36-6-501.11-.12
Improper Maintenance of Floors
Clean floor under and behind cooking equipment prep tables grease trap and shelves. Clean floor in basement. Clean floor behind bar.
Why This Matters
CONTAMINATION RESERVOIR: Damaged floors harbor bacteria in cracks. Standing water breeds Listeria, Pseudomonas. Broken tiles create pest harborage. Floor contamination spreads via shoes, equipment wheels, and dropped items. CDC found floor drains positive for Listeria in 40% of retail delis.
Code Requirements
Floors must be: Smooth and non-porous in food areas; Properly sloped to drains (1/8 to 1/4 inch per foot); Coving at wall junctures sealed; No cracks, holes, or missing tiles; Grout intact and sealed; Cleaned daily or more frequently; Dry except when cleaning.
Corrective Actions
Schedule floor repairs within 30 days; Seal all cracks immediately with approved sealant; Improve drainage to eliminate standing water; Increase cleaning frequency; Replace missing tiles; Re-grout as needed; Remove any carpeting from food areas
37-6-501.11-.12
Improper Maintenance of Walls/Ceilings
Hood filters visibly soiled. Clean Hood sticker expired June 2018. Have hood cleaned. Clean walls in kitchen. Soiled around fan in kitchen. Replace ripped and peeling ceiling tiles.
Why This Matters
OVERHEAD CONTAMINATION: Peeling paint and debris fall into food. Condensation on ceilings drips bacteria onto prep surfaces. Studies found ceiling tiles harbor Bacillus cereus spores. Restaurant ceiling collapse contaminated food service for 200 guests.
Code Requirements
Walls/ceilings must be: Smooth and washable in food areas; Light-colored for easy soil detection; Free of holes, cracks, peeling paint; Sealed at all joints and attachments; Clean and free of grease, dust, cobwebs; Non-absorbent in areas subject to moisture.
Corrective Actions
Repair all holes within 14 days; Repaint with washable paint; Replace damaged ceiling tiles; Seal all penetrations; Clean walls and ceilings monthly; Fix any leaks immediately; Install FRP panels in splash zones