BLASI'S CAFE
PASSFriday, August 28, 2015 at 6:36 PM
Violations Cited
03-3-501.16(A)
Cold Holding
Cooked breaded chicken breasts inside of teh single door deli cooler near the steam tables with an elevated temperature of 80F. Ensure all potentially hazardous foods are being maintained at below 41F.
Why This Matters
THE DANGER ZONE KILLS: Between 41°F-135°F bacteria double every 20 minutes. At 70°F, 10 bacteria become 10,000 in 2 hours, 10 million in 4 hours. Staphylococcus aureus produces heat-stable toxins that cooking cannot destroy. Clostridium perfringens causes 1 million illnesses yearly from temperature abuse. Listeria grows even under refrigeration, killing 20% of victims including pregnant women and newborns.
Code Requirements
ALL TCS foods MUST be held at 41°F or below at ALL times. This includes: All meat, poultry, seafood; Dairy products; Cut melons, tomatoes, leafy greens; Cooked rice, pasta, potatoes; Tofu, soy products; Sprouts; Garlic in oil. Check temperatures every 2 hours (4 hours maximum). If above 41°F for less than 2 hours, rapidly cool. If above 41°F for 2-4 hours, use immediately. If above 41°F for over 4 hours, DISCARD.
Corrective Actions
IMMEDIATE: Check ALL refrigerated foods NOW; Discard any food above 41°F for >4 hours; Rapidly cool foods 41-70°F if <4 hours; Repair/adjust all refrigeration immediately; Reduce inventory to prevent overstocking; Install thermometers in warmest part of all coolers; Implement 2-hour temperature checks; Create power outage procedure
10-3-304.12
Food Utensil Storage
Tongs being used for food service observed being stored hanging on the hand sink near the front service area. Discontinue and store in a clean and protected area.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper equipment procedures. Train all staff. Document corrective actions taken.
14-4-202.11
Food Contact Surfaces Design
Long cutting board over the 2 door deli style cooler visibly soiled and heavily scoared. Resurface or replace.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
15-4-202.16
Non-Food Contact Surfaces
Walk-in freezer with an elevated temperature of 30F. Discontinue use if the unit is unable to maintain all foods frozen. PIC stated it may be possibly going through a defrost cycle. At the time of the inspection all foods inside of the walk-in were frozen. Address and make any necessary repairs.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
17-4-302.14
Test Kit Provided
No test kit available for the quartinary ammonium sanitizer. Provide.
Why This Matters
This violation affects overall sanitation and food safety
Code Requirements
Immediate correction required. Follow health code section . Implement proper food safety procedures. Train all staff. Document corrective actions taken.
23-4-602.13
Non-Food Contact Surfaces Clean
Lower shelf of the deli cooler at the front service station visibly soiled with excess water and does not appear to be draining properly. Address and mak all of the necesary repairs.
Why This Matters
INDIRECT CONTAMINATION: Dirty surfaces attract pests, harbor bacteria, and contaminate via contact or air movement. Dust from dirty shelves contains allergens affecting 32 million Americans. Grease accumulation creates slip hazards causing 25% of restaurant injuries.
Code Requirements
Non-food contact surfaces must be cleaned at frequency to prevent: Soil accumulation; Pest attraction; Contamination of food/food contact surfaces. Includes: Equipment exteriors; Shelving; Walls and ceilings; Light fixtures; Ventilation systems.
Corrective Actions
Deep clean all non-food contact surfaces; Create cleaning schedule with daily, weekly, monthly tasks; Assign cleaning zones to staff; Use degreaser for grease accumulation; Clean from top to bottom; Maintain cleaning log